HP Stream 7 Motherboard Replacement

Última atualização em October 9, 2018

5 minutos

Moderado

Introdução

Before beginning, make sure you discharge any static electricity stored in your hands by either touching a metal object (preferably grounded) or using the anti-static wrist strap.

O que você precisa

Ferramentas

Exibir mais…

Passo 1 Battery

HP Stream 7 Motherboard Replacement, Battery: passo 1, imagem 1 %32

HP Stream 7 Motherboard Replacement, Battery: passo 1, imagem 2 %32

Make sure the tablet is powered off before beginning.
Gently run the plastic opening tool or your fingernails around the tablet to pry the Back Cover from the tablet.

Editar

Passo 2

Remove the eight 5 mm Phillips 000 screws.
Gently run the plastic opening tool around the seam to pry the mid back cover from the tablet.

Editar

Passo 3

Ferramenta utilizada neste passo:

Tweezers

$4.99

Adicionar ao carrinho

Using tweezers, gently pull the battery connector towards the battery to remove it from the System Board.
Pull the blue tabs (Not Shown) out from the tablet at an angle to remove the tape underneath the Battery.
If you broke both tabs, scrape the tape and Battery off.
Scraping off the Battery will damage it. If you are replacing another part, leave the Battery on the display panel.

Editar

Passo 4 Motherboard Replacement

HP Stream 7 Motherboard Replacement, Motherboard Replacement: passo 4, imagem 1 %32

Disconnect the battery from the motherboard, but leave the battery on the display panel (unless you have already taken it off).
Disconnect the motherboard from the rear-facing camera, the front-facing camera, the antenna, the power button board, the screen, and the display panel using your spudger.
The cable connected to the display is adhered to the panel, so be careful when removing the cable (like most things here).
If you are inexperienced with disconnecting everything, "Recognizing and Disconnecting Cable Connectors" is a helpful ifixit guide.