Introdução

A good hard drive is essential to an optimally performing computer. If your computer is slowing down, a new hard drive may be exactly what your device needs to start functioning at its maximum potential.

Peças

Não são necessárias peças.

  1. Flip the device over and locate the battery compartment.
    • Flip the device over and locate the battery compartment.

    • Slide the battery release latch, which you can see in the picture, to the left until the battery is detached from its slot.

    • A distinguishable pop will be heard when the battery is fully released.

    Adicionar comentário

  2. Slowly pull the battery out of its slot, being careful not to damage any of the connectors in the process.
    • Slowly pull the battery out of its slot, being careful not to damage any of the connectors in the process.

    Adicionar comentário

    • Locate the Phillips head screw securing the RAM compartment cover.

    • Loosen the screw that is securing the RAM compartment with a Phillips #00 screwdriver.

    • The screw is permanently attached to the RAM compartment cover. Do not try to remove it completely.

    Adicionar comentário

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Once the screw is sufficiently loosened, slowly unclip the RAM compartment cover from its slots in the plastic chassis.

    • When unclipped completely, pull the compartment door out and away from the chassis.

    Adicionar comentário

    • Locate the two Phillips head screws that are securing the hard drive compartment.

    • Using a Phillips #00 screwdriver, loosen both screws.

    • The screws are permanently attached to the hard drive compartment cover. Do not try to remove them completely.

    • Once the screws are sufficiently loosened, disconnect the clips holding the cover in place and slowly pull the cover away from the plastic chassis.

    Adicionar comentário

    • Locate the hard drive connecting cable to the right of hard drive.

    • Using a spudger, disconnect the hard drive connecting cable. Use a slow, prying motion as if pulling a nail out of wood.

    • Be very gentle with the connecting cable and its respective port on the logic board. Both are very fragile and can be easily damaged.

    Adicionar comentário

    • Using your fingers, grab the blue tab on the right side of the hard drive and slowly pull upwards.

    • Lift the hard drive out and away from its socket in the plastic chassis.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

21 outras pessoas concluíram este guia.

Conor Most

Member since: 14-04-2014

2.256 reputação

6 Guides authored

Equipe

Cal Poly, Team 3-40, Maness Spring 2014 Membro de Cal Poly, Team 3-40, Maness Spring 2014

CPSU-MANESS-S14S3G40

4 Membros

6 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 5

Últimos 7 dias: 52

Últimos 30 dias: 201

Todo: 9,612