Participe da comunidade de reparos - Criar conta

Introdução

This guide will give step by step instructions to removing the headphone jack from a Google Pixel C tablet.

O que você precisa

1. Passo 1 Screen
  Ensure that the device is completely powered down before beginning to take it apart
  
  Use a heat gun to melt the adhesive that holds the screen to the device
  
  Move the heat gun around the edge of the screen for approximately 1 minute, or until the screen can be lifted off in the next step.
  
  Make sure not to heat the screen for too long because too much can damage other components inside the tablet.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
2. Passo 2
  Use a suction cup to assist in lifting the screen while prying around its edges with a plastic spudger.
  
  If necessary use a metal spudger to pry the screen up, taking care not to scratch the device.
  
  Be careful not to pull the screen too far off. It will still be attached to the device by a cable for the front facing camera and the wide display data cable.
  
  Reattaching the screen will require adhesive to ensure that it stays in place.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
3. Passo 3
  Detach the cables for the camera by lifting the small flap using the tip of your fingernail or a spudger. Gently pull the ribbon cable out.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
4. Passo 4
  Ferramenta utilizada neste passo:
  Tweezers
  $4.99
  
  Comprar
  Follow the same removal procedure to detach the wide gold cable.
  
  When reattaching cables, it is helpful to use tweezers to slide the cable in before securing it down with the flap.
  
  This device is missing a battery, so the device that you are working on may appear slightly different inside.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
1. Passo 5 Headphone Jack
  Orient the device so that the headphone jack is in the bottom right corner.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
2. Passo 6
  Remove the two 3.5mm Phillips #000 screws.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
3. Passo 7
  Locate and remove the two 2.5mm Phillips #000 screws on either side of the wire coil.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
4. Passo 8
  Detach the red and black cable using a narrow spudger.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
5. Passo 9
  Detach the cable connecting to the headphone jack.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
6. Passo 10
  Lift the headphone jack, coiled wire, and cable, peeling the adhesive back.
  
  Reassembly will require adhesive to ensure that the components are secured to the device.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024