Conserte seus objetos Comunidade Loja

GoPro Hero+ LCD MicroSD/Micro USB Port Assembly Replacement

Introdução

Use this guide to replace the microSD/Micro USB port assembly in your GoPro Hero+ LCD.

O que você precisa

  1. GoPro Hero+ LCD MicroSD/Micro USB Port Assembly Replacement, Back Panel: passo 1, imagem 1 %32 GoPro Hero+ LCD MicroSD/Micro USB Port Assembly Replacement, Back Panel: passo 1, imagem 2 %32

    • Be sure to power off the GoPro before you start disassembly.

    • Pop up and pull back on the clip to remove the screen cover and expose the back panel with the touchscreen.

    Editar

  2. GoPro Hero+ LCD MicroSD/Micro USB Port Assembly Replacement: passo 2, imagem 1 %32 GoPro Hero+ LCD MicroSD/Micro USB Port Assembly Replacement: passo 2, imagem 2 %32

    • Use the metal spudger to pry around the perimeter of the panel.

    • Pry the panel upwards by inserting the metal spudger into the corner crease between the panel and camera shell.

    Editar

  3. GoPro Hero+ LCD MicroSD/Micro USB Port Assembly Replacement: passo 3, imagem 1 %32 GoPro Hero+ LCD MicroSD/Micro USB Port Assembly Replacement: passo 3, imagem 2 %32

    • Pry around the panel to ensure it is not attached to the device.

    • Move the panel to the side so you can access the internal components.

    • The panel is still attached to the rest of the device with a ribbon cable, so be sure to not tear or damage the cable.

    Editar

  4. GoPro Hero+ LCD MicroSD/Micro USB Port Assembly Replacement, Battery: passo 4, imagem 1 %32

    • Peel back the rear panel ribbon cable that is adhered to the battery until it is completely separated from the battery.

    • Be careful of metal contacts on strip; they can be sharp.

    Editar

  6. GoPro Hero+ LCD MicroSD/Micro USB Port Assembly Replacement: passo 5, imagem 1 %32

    • Using tweezers, peel off the copper tape on the right side of the battery.

    Editar

  7. GoPro Hero+ LCD MicroSD/Micro USB Port Assembly Replacement: passo 6, imagem 1 %32 GoPro Hero+ LCD MicroSD/Micro USB Port Assembly Replacement: passo 6, imagem 2 %32

    • Place the plastic opening tool at one of the edges of the battery then pry until the battery is removed from the GoPro.

    Editar

  8. GoPro Hero+ LCD MicroSD/Micro USB Port Assembly Replacement: passo 7, imagem 1 %32

    • Use a pair of tweezers to disconnect the battery connector from the motherboard.

    • Gently pull the battery off the motherboard. Pulling vertically off the motherboard will give a clean release.

    Editar

  9. GoPro Hero+ LCD MicroSD/Micro USB Port Assembly Replacement, MicroSD/Micro USB Port Assembly: passo 8, imagem 1 %32 GoPro Hero+ LCD MicroSD/Micro USB Port Assembly Replacement, MicroSD/Micro USB Port Assembly: passo 8, imagem 2 %32 GoPro Hero+ LCD MicroSD/Micro USB Port Assembly Replacement, MicroSD/Micro USB Port Assembly: passo 8, imagem 3 %32

    • Remove the two 6 mm Phillips #00 screws.

    • Remove the single 4 mm Phillips #000 screws.

    Editar

  10. GoPro Hero+ LCD MicroSD/Micro USB Port Assembly Replacement: passo 9, imagem 1 %32

    • Remove the image sensor from the camera.

    • You do not have to unplug the black box to remove the USB/SD chip.

    Editar

  11. GoPro Hero+ LCD MicroSD/Micro USB Port Assembly Replacement: passo 10, imagem 1 %32

    • Grab the edge of the ribbon cable with the tweezers and gently pull until the cable is disconnected from the motherboard.

    • Be careful when removing the ribbon cable. You must pull gently or you can rip the ribbon off of its contacts.

    Editar

  12. GoPro Hero+ LCD MicroSD/Micro USB Port Assembly Replacement: passo 11, imagem 1 %32

    • Gently lift the microSD/Micro USB assembly up and out of the device.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

5 outras pessoas executaram este guia.

Autor(a)

com 6 outros contribuidores

Shariyf Mitchell

Membro desde: 08/27/15

201 Reputação

Autoria de 1 guia

Emblemas: 9

+6 outros emblemas

Equipe

USF Tampa, Team 2-4, Blackwell Fall 2015 Membro de USF Tampa, Team 2-4, Blackwell Fall 2015

USFT-BLACKWELL-F15S2G4

Membros da 4

Autoria de 20 guias

2 comentários

Hi were can i buy the microSD/Micro USB port assembly in your GoPro Hero+ LCD.

Hector - Responder

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 9

Últimos 30 dias: 23

Duração total: 3,076