Participe da comunidade de reparos - Criar conta

Introdução

This guide will help you replace the USB spring should it need replacement. The only tool needed is the Phillips #1 Screwdriver. It should only take 10 minutes.

O que você precisa

1. Passo 1 USB spring
  Unlock the battery cover by sliding the switch to the unlock position.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
2. Passo 2
  Remove the battery cover by sliding it down the camera.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
3. Passo 3
  Remove the batteries
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
5. Passo 4
  Slide the black upper casing off from the device.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
6. Passo 5
  Remove the six 1mm screws from the back and upper casing with the Phillips Head screwdriver.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
7. Passo 6
  Remove the top casing from the bottom to reveal the inner circuit board.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
8. Passo 7
  When removing the back panel, the rubber buttons will become loose and likely fall off the board. This is normal and can easily placed back on the board once finished.
  
  Remove the six 1mm screws with the 1 Phillips head screwdriver.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
9. Passo 8
  Gently separate the circuit board from the casing.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
10. Passo 9
  Using the Phillips head screwdriver, disconnect spring from the plastic nubs.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024