Conserte seus objetos Comunidade Loja

Drill Master Heat Gun Power Switch Replacement

Introdução

This requires soldering, so for a quick lesson or just a refresher, check out How to Solder and Desolder Connections.

O que você precisa

  1. Drill Master Heat Gun Power Switch Replacement, Power Switch: passo 1, imagem 1 %32

    • Be sure the heat gun is unplugged before starting this process.

    • Remove the seven 14mm screws from the side of the drill using the PH#0 screwdriver.

    • You will need a screwdriver extension.

    Editar

  2. Drill Master Heat Gun Power Switch Replacement: passo 2, imagem 1 %32

    • Remove the 8mm screw from underside of barrel using the PH#0 screwdriver.

    • Don't try to open the casing just yet.

    Editar

  3. Drill Master Heat Gun Power Switch Replacement: passo 3, imagem 1 %32 Drill Master Heat Gun Power Switch Replacement: passo 3, imagem 2 %32 Drill Master Heat Gun Power Switch Replacement: passo 3, imagem 3 %32

    • Remove the barrel casing on either end by twisting and pulling each side off.

    Editar

  5. Drill Master Heat Gun Power Switch Replacement: passo 4, imagem 1 %32

    • Remove the top casing to reveal inside of drill. You might have to tug a little harder for this one.

    Editar

  6. Drill Master Heat Gun Power Switch Replacement: passo 5, imagem 1 %32

    • Loosen four screws on the wire connector using the flathead 2.5 screwdriver.

    • Screws do not come out of connector.

    Editar

  7. Drill Master Heat Gun Power Switch Replacement: passo 6, imagem 1 %32

    • Squeeze the tabs on either side of the power switch to remove from the casing.

    Editar

  8. Drill Master Heat Gun Power Switch Replacement: passo 7, imagem 1 %32 Drill Master Heat Gun Power Switch Replacement: passo 7, imagem 2 %32

    • Remove the black, plastic wire protectors from the end of the power switch.

    Editar

  9. Drill Master Heat Gun Power Switch Replacement: passo 8, imagem 1 %32

    • Use soldering iron to remove the electrical wiring from the power switch. To replace the power switch, solder the new switch onto the wires.

    • Heating the soldering metal will allow you to pull off the electrical wiring.

    • For a brush-up on proper soldering, check out How to Solder and Desolder Connections.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 6

Últimos 30 dias: 23

Duração total: 2,787