Participe da comunidade de reparos - Criar conta

Introdução

If your drill has no power, the wires in the power cord may have been frayed or become severed. This guide will help you replace the power cord in your DeWalt DWD112.

O que você precisa

1. Passo 1 Power Cord
  Remove seven TR20 Torx Security screws from the side of the drill.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
2. Passo 2
  Remove the top cover to reveal the inside of the drill.
  
  Set the top cover of the drill aside.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
3. Passo 3
  The power cord and the trigger act as a single part and must be replaced together.
  
  Using one hand grab the trigger box and with the other grab the end of the wire connecting to the trigger box and disconnect the wire.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
5. Passo 4
  Disconnect the second connected wire from the top of the trigger box.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
6. Passo 5
  Lift the trigger box up to reveal the bottom side.
  
  Disconnect the first connected wire from the bottom of the trigger box.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
7. Passo 6
  Disconnect the last wire from the trigger box using the same method from the previous step.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
8. Passo 7
  After all four wires are disconnected, the trigger and power cord are separated from the drill.
  
  The power cord and trigger can be set aside if further disassembly is required.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024