Ir para o conteúdo principal

Carrera Mario Copter Controller Circuit Board Replacement

O que você precisa

  1. Carrera Mario Copter Controller Circuit Board Replacement, Controller Circuit Board: passo 1, imagem 1 %32
    • Flip the controller over so the underside would face up

    • Remove four of 7.1mm screws with a JIS #1 screwdriver

    • Remove two 4.0mm screws located on the handle with the JIS #1screwdriver.

    • Remove two 7.1 mm screws on the small area that stick out from the surface with the JIS #1 screwdriver

    • Use an extension with the JIS #1 screwdriver in order to get to the screws with yellow marks because they locate deep inside the holes.

  2. Carrera Mario Copter Controller Circuit Board Replacement: passo 2, imagem 1 %32
    • Remove the black case to access the circuit board.

    • Remove two 4.8mm screws on the circuit board with the JIS #1 screwdriver.

  3. Carrera Mario Copter Controller Circuit Board Replacement: passo 3, imagem 1 %32
    • Gently lift up the circuit board from the black case.

    • Use a soldering iron to melt the red wire while at the same time pulling it from the motherboard.

    • For more information on how to solder and desolder connections, please visit this guide.

    • Repeat the previous procedure with the black wire.

    • Gently remove the circuit board away from the case.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Equipe

UW Tacoma, Team S1-G6, Rose Fall 2017 Membro de UW Tacoma, Team S1-G6, Rose Fall 2017

UWT-ROSE-F17S1G6

Membros da 4

Autoria de 10 guias

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 3

Duração total: 255