Introdução

Screens can be cracked and broken or stop working completely. This guide will show how to replace the screen in the device.

  1. Remove the 2.0 mm Phillips screws on both sides of the camera using the Phillips #00 screwdriver.
    • Remove the 2.0 mm Phillips screws on both sides of the camera using the Phillips #00 screwdriver.

    • There will be 4 total screws that need to be removed, 2 on each side.

    Adicionar comentário

  2. Remove the 4.0 mm Phillips screw located on the bottom of the camera.
    • Remove the 4.0 mm Phillips screw located on the bottom of the camera.

    Adicionar comentário

    • Remove the front face panel of the camera.

    • The face can be removed by hand with a firm pressure. If one point of the face is stuck to the body, ensure that there is not a screw remaining at that position to hold it in place.

    Adicionar comentário

    • Remove the rear panel of the camera.

    Adicionar comentário

    • Remove the panel of buttons by hand.

    Adicionar comentário

    • Remove the 3.0 mm Phillips copper colored screw from the top of the camera.

    Adicionar comentário

    • Remove the 3.0 mm Phillips silver screw from the rear face of the camera, located on the upper right corner.

    Adicionar comentário

    • Using the plastic spudger, pry the golden film on the front face of the camera off of the microchip.

    • Once removed, a silver screw will be visible from underneath the golden film.

    Adicionar comentário

    • Remove the 3.0 mm Phillips silver screw using the screwdriver.

    Adicionar comentário

    • Using the metal spudger, carefully pry the small black tab away from the brown film end of the golden film.

    • Once released, the small black tab will point straight away from the front face of the camera.

    • After releasing the tab, the golden film will no longer be secured to the front face of the camera.

    Adicionar comentário

    • Unplug the small chip from the face of the camera by carefully inserting the metal spudger underneath the cluster of red wires visible. Then lift the cluster of wires upwards, parallel to the front face of the camera.

    Adicionar comentário

    • You can now remove the top panel from the camera using your hands with firm pressure.

    Adicionar comentário

    • Insert the metal spudger underneath the golden film on the front face

    • Lift the golden film on the front face of the camera up and away from its connection

    Adicionar comentário

    • Remove the screen by sliding the golden film out of the channel and pulling the screen away from the camera.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

3 outras pessoas concluíram este guia.

Braxton Beal

Member since: 30-01-2018

672 reputação

3 Guides authored

Equipe

Baylor, Team S1-G3, Johnson Spring 2018 Membro de Baylor, Team S1-G3, Johnson Spring 2018

BU-JOHNSON-S18S1G3

3 Membros

4 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 6

Todo: 116