Introdução

This guide teaches how to to install the back panel latch on your camera.

Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.
  • Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.

Adicionar comentário

Using your finger, peel back the textured grip so the components are separated.
  • Using your finger, peel back the textured grip so the components are separated.

Adicionar comentário

  • Using the flat end of a spudger, loosen the connection between the front panel and the device.

  • Remove the front panel using your hands.

Adicionar comentário

  • Using a 00 Phillips screw driver, unscrew the two screws located on the side of the camera.

    • Two 4.3 mm Phillips screws

Adicionar comentário

  • Open the back panel by pushing the locking latch up.

  • Lift the latch cover off of the camera body.

Adicionar comentário

  • Slide the side latch (for the back door) up and then lift straight away from the camera body.

  • Sometimes the latch will detach while pushing it up.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Zach

Member since: 04-04-2012

40 reputação

8 Guides authored

Equipe

Cal Poly, Team 14-9, Forte Spring 2012 Membro de Cal Poly, Team 14-9, Forte Spring 2012

CPSU-FORTE-S12S14G9

5 Membros

12 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 7

Últimos 30 dias: 15

Todo: 1,646