Anker 2.4G Wireless Mouse LED Replacement

Participe da comunidade de reparos - Criar conta

Introdução

This guide shows how to replace the LED on the Anker 2.4G Wireless Mouse. The mouse will stop working if the LED inside stops working. Instead of throwing out a mostly functioning product, simply replace the LED and get the mouse working again.

O que você precisa

1. Passo 1 LED
  Use a spudger to gently pry off the stickers to reveal the location of the four screws.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
2. Passo 2
  Remove the four screws to continue.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
3. Passo 3
  Pry the center of the mouse apart using a spudger to separate the upper and lower housing of the boards.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
5. Passo 4
  Remove the wires from the white crimp headers. This will separate the upper and lower housing units of the mouse.
  
  Pull as far up on the wire as possible, but be careful to avoid ripping the wires.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
6. Passo 5
  Take the upper housing of the mouse and remove the two screws that hold the board in place.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
7. Passo 6
  Gently remove the circuit board from the mouse.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024
8. Passo 7
  To remove the LED, flip the board over and desolder the wires.
  
  Replace LED with a new LED and resolder into place.
  Editar
  
  Pergunte ao FixBot
  
  Comentar
  
  1024