Ir para o conteúdo principal

O que você precisa

  1. Aluratek ADMPF310F Replacing USB Port Replacement, Motherboard: passo 1, imagem 1 %32 Aluratek ADMPF310F Replacing USB Port Replacement, Motherboard: passo 1, imagem 2 %32 Aluratek ADMPF310F Replacing USB Port Replacement, Motherboard: passo 1, imagem 3 %32
    • Using the black nylon spudger, pry off the clips all around the frame. You will hear a popping sound for every clip

    • Be sure not to pry to hard because you could crack or break the plastic facing of the device.

  2. Aluratek ADMPF310F Replacing USB Port Replacement: passo 2, imagem 1 %32
    • Lift screen out of place so you can access the plugs that connect it.

  3. Aluratek ADMPF310F Replacing USB Port Replacement: passo 3, imagem 1 %32 Aluratek ADMPF310F Replacing USB Port Replacement: passo 3, imagem 2 %32
    • Using the plastic spudger tool lift the plastic zif(zero instertion force) connector clip up.

    • Pull the ribbon cable away from the mother board.

    • Be careful as this zif connector is very frail plastic.

  4. Aluratek ADMPF310F Replacing USB Port Replacement: passo 4, imagem 1 %32
    • Disconnect the red and black cable connecting the screen to the motherboard by just pulling it out.

  5. Aluratek ADMPF310F Replacing USB Port Replacement: passo 5, imagem 1 %32
    • Pull out remote receiver out of its clip.

    • Be careful to not move the wires around for the remote receiver too much, as they are soldered to the motherboard.

  6. Aluratek ADMPF310F Replacing USB Port Replacement: passo 6, imagem 1 %32 Aluratek ADMPF310F Replacing USB Port Replacement: passo 6, imagem 2 %32
    • Using fingers pull the first speaker wire that is located closest to the speakers

    • Again using your fingers, pull out the second speaker wire near the far side of the motherboard.

  7. Aluratek ADMPF310F Replacing USB Port Replacement: passo 7, imagem 1 %32 Aluratek ADMPF310F Replacing USB Port Replacement: passo 7, imagem 2 %32 Aluratek ADMPF310F Replacing USB Port Replacement: passo 7, imagem 3 %32
    • Using the ph0 phillips head screwdriver unscrew the four 4mm screws circled in the picture.

  8. Aluratek ADMPF310F Replacing USB Port Replacement: passo 8, imagem 1 %32
    • Pull up the smaller end of the motherboard.

    • Apply force pulling away from the USB ports to get the mother board out of place.

  9. Aluratek ADMPF310F Replacing USB Port Replacement, USB Port: passo 9, imagem 1 %32
    • On the back end of the mother board unsolder the USB port at the two points shown.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Pascal Alexis

Membro desde: 05/11/2015

427 Reputação

3 Guias de autoria

Equipe

UMass Dartmouth, Team 5-1, Martin Fall 2016 Membro de UMass Dartmouth, Team 5-1, Martin Fall 2016

UMASSD-MARTIN-F16S5G1

3 Membros

5 Guias de autoria

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 2

Duração total: 103