Last modified: 17/02/2021 10:17:45

Decor Trim - Instrument Panel - Main (Remove and Replace)

Correction code 14057002

FRT 0.10

NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.

NOTE: See to learn more about FRTs and how they are created. To provide feedback on FRT values, email . Make sure to wear proper PPE when performing below procedure. Flat Rate Times LaborTimeFeedback@tesla.com

Remove

• Remove the LH instrument panel end cap. See . End Cap - Instrument Panel - LH (Remove and Replace)

• Remove both the LH air wave end cap. See . End Cap - Air Wave - LH (Remove and Replace)

• Repeat steps and for the RH side of the vehicle. 1 2

• Release the clips that attach the main instrument panel decor trim, and then remove the trim from the instrument panel.

Install

Installation procedure is the reverse of removal, except for the following:

• Check for any damaged clips and replace them as necessary.
• Make sure that the instrument panel decor trim clips are fully seated to the instrument panel.
• Use Toolbox to perform an air wave functionality check to make sure the instrument panel decor trim clips are fully seated.