SUBARU®

INSTALLATION INSTRUCTIONS

SECURITY SYSTEM UPGRADE LEGACY

P/N: H7110LS200

NOTE: This system requires prior installation of Keyless Entry System. If installing both systems at the same time, install the Keyless Entry System first.

Kit Contents:

1 Security Control Module w/Integral Bracket

1 Starter Interrupt/Horn Relays w/Integral Bracket

1 Horn w/Integral Bracket

1 Security Radio Mounting Bracket

2 Pan Head Screws (M5×8mm)

2 M6 Nuts

2 Window Decals

1 Installation Manual

Tools Required:

1 Flat-tip Screwdriver

2 Phillips Head Screwdriver

Electrical Tape

1/4" Drive Ratchet

10-inch 1/4" Drive Extension

10mm Socket

⊕

This device complies with FCC rules part 15. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference that may cause undesired operation.

A. Pre-Installation Notes

1. Vehicle Preparation

a. Lower the driver's side window to avoid inadvertently locking the keys in the vehicle during installation.

b. Disconnect negative battery terminal to prevent accidental shorting of any power circuits.

System Preparation

⊕

Remove the security module from the package and inspect for any physical damage.

3. Shock Sensor Adjustment

The shock sensor adjustment knob is recessed inside the unit and is covered by a protective seal.

This adjustment is PRESET at the factory.

B. Security Module Installation

1. Remove the gearshift cover by pulling up in areas indicated by arrows in Figure 1.

a. For automatic transmission, shifter must temporarily be placed into neutral.

b. For standard transmission, the shift knob must be removed by unscrewing.

1111

2. Remove the tray by removing the two screws indicated by arrows in Figure 2.

Figure 1

3. Remove the ashtray. Disassemble ashtray assembly by removing the two screws indicated by arrows in Figure 3.

Figure 2

⊕

↓↑

Figure 3

4. Lift the center console cover by carefully pulling outward in areas indicated by arrows in Figure 4.

5. Remove the six screws indicated by the arrows in Figure 5. Do not disconnect any connectors. Pull the unit out just far enough to access the passenger side of the unit. See Figure 6.

NOTE: While the HVAC unit is pulled forward, the ASPIRATOR SENSOR hose (located on the driver's side of the HVAC unit) may disconnect. The hose must be reconnected during re-installation.

⊕

6. Install the security radio mounting bracket per Figure 6, by first removing all radio, CD, etc. mounting screws visible on passenger side of car radio bracket. Locate and install security radio mounting bracket utilizing these screws.

7. Locate