Fixing broken blue wire to speaker
So I was following the repair to replace the front panel and got a bit ahead of myself and took the EMI shield off a little too quickly and as a result snapped the blue wire from the external speaker housing -.-
I am very bad at soldering and I have possibly the worst solder tip and solder known to man. However I just about managed to solder an additional length of wire (from a pair of headphones) onto the broken blue cable and then soldered the new wire onto the connection on top, quite poorly I may add.
The sound now works up to about 10% of the volume and anything above that is just heavy noise.
Does anyone have any ideas how I could fix this, would re-soldering help? Would really like to get this back like new.
Esta é uma boa pergunta?