I know how to solder and would like to remove the port completely and just have the powerblock permanently attached, I don't know how to tell whats positive, negative, neutral. Any help would be appreciated
Esta é uma boa pergunta?
Rep: 1,5 mil
10
1
2
You need to use a multimeter, to check voltage and to check resistance (ohms). Even a cheap multimeter from amazon will work.
The center of the plug that goes into the laptop is usually positive. +20 volts dc. The outside ring is then ground, 0 volts.
If you are soldering inside the laptop you have to solder the + wire to where the tip/center metal connects. Use the ohms setting of the multimeter the tip to wire resistence to confirm where the + wire is soldered.
But there is risk of course. If you're not careful inside you could damage the laptop.
Esta resposta foi útil?
Últimas 24 horas: 0
Últimos 7 dias: 0
Últimos 30 dias: 2
Duração total: 9
