Rep: 23
1
The eject button labeled SW1 on the motherboard has gone limp and no longer clicks in. Is there hope of buying a replacement part and soldering it in or will I need to buy a new motherboard?
Esta é uma boa pergunta?
Rep: 32,9 mil
24
35
32
These look pretty standard as far as buttons go. I was able to find an ebay listing for just button components fairly easily.
I suspect most of the challenge would be finding the right form factor for the button, This looks like a very cut-and-dry solder job though, and not too challenging.
Esta resposta foi útil?
Últimas 24 horas: 0
Últimos 7 dias: 1
Últimos 30 dias: 3
Duração total: 48
2 comentários
@radicalstr13497 Can you upload pictures of the button and where/how it mounts to the circuit board?
por Andrew S
@andrewsawesome Done sorry for the poor quality
por Radical Strawberry