Ir para o conteúdo principal

This printer is a more expensive upgrade from the Ender 3, with bigger knobs, a new toolbox, and a "brand new user interface" among other things.

4 Perguntas Visualizar todos

after the gcode file is taken by the sim card the printer not printing

the file was in sim card and the 3d printer was shown the file but when i click on it it is no doing it imdly so i have to wait for a while or it should imdly work on it.

Responder a esta pergunta Também tenho esse problema

Esta é uma boa pergunta?

Pontuação 0
Adicionar um comentário

2 respostas

The printer waits till all the heated parts are up to the programmed temperature before the print starts.

Hope this helps.

Esta resposta foi útil?

Pontuação 0
Adicionar um comentário

make sure you have installed the proper firmware on the motherboard via the SD card.

Don't be a muppet, get the download straight from creality.

If that doesn't work, then if you are using a 4.2.7 motherboard, make sure your UI is the new touchscreen one.

If its a 4.2.2 then you should be fine

Esta resposta foi útil?

Pontuação 0
Adicionar um comentário

Adicionar a sua resposta

cdsc será eternamente grato(a).
Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 16

Duração total: 48