Is it the power supply? Lit LED, 1 none else.

Question

iMac G5 20" Model A1145

2.1 GHz G5 processor

77 Perguntas Visualizar todos

philaro @philaro

Rep: 21

2

Postado: 27 de jan de 2012

Opções

Is it the power supply? Lit LED, 1 none else.

LED stays lit when I plug my iMac G5 in, but when I push the power button, LED 2 flickers on for less than a second and then goes off again. The iMac stays black.

I have tried to reset the SMU by plugging it in while holding the power button, but nothing has changed.

The computer became bricked after a brief power outage (and was the only machine in the house not on a power strip).

mayer wrote responding to "Where is a decoder for diagnostic LED pattern"

LED 1 indicates that trickle voltage from the power supply has been detected. This LED will be ON when the computer is turned off and your power supply is working correctly.

LED 2 indicates that the main logic board has detected proper power

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não

Pontuação -1

Adicionar um comentário

2 respostas

Solução escolhida

mayer @mayer

Rep: 685,3 mil

MacHale Enterprises

3,4 mil

1,1 mil

2,6 mil

Postado: 28 de jan de 2012

Opções

Replace your power supply.

Esta resposta foi útil?

Sim Não

Pontuação 5

3 comentários:

Thanks. I'll order one and see how it goes!

29 de jan de 2012 por philaro

Well it was the power supply - I'm using the computer to write this follow up. It didn't take hours to fix either - it took half an hour.

I discovered that you may not need to do more than get the front bezel off and lift up the display to swap out the power unit - the hidden connector that otherwise takes hours of disassembly to get at pulls out with a bit of firm-but-gentle sideways wiggling.

My step 18 note "If you are changing the power supply - this is a good point to remove the screws to the old power supply to see if the connectors (both of them) are accessible. If you can gently (but firmly) pull the two-wire connector out from under the chassis, you can install the new unit at this step ...

Live on iMac G5, live on!

7 de fev de 2012 por philaro

Glad I could help you solve your problem ;-)

8 de fev de 2012 por mayer

Adicionar um comentário

Well it was the power supply - I'm using the computer to write this follow up. It didn't take hours to fix either - it took half an hour.

I discovered that you may not need to do more than get the front bezel off and lift up the display to swap out the power unit - the hidden connector that otherwise takes hours of disassembly to get at pulls out with a bit of firm-but-gentle sideways wiggling.

My step 18 note "If you are changing the power supply - this is a good point to remove the screws to the old power supply to see if the connectors (both of them) are accessible. If you can gently (but firmly) pull the two-wire connector out from under the chassis, you can install the new unit at this step ...

Live on iMac G5, live on! — philaro

Jimmyn86 @jimmyn86 Rep: 1 · Answer 1 · 2013-02-01T00:35:27-07:00

Jimmyn86 @jimmyn86

Rep: 1

Postado: 1 de fev de 2013

Opções

I have the same problem only 1 led light up.I have an imac 27 "intel. might be power supply?

Esta resposta foi útil?

Sim Não

Pontuação 0

Adicionar um comentário

iMac G5 20" Model A1145

Is it the power supply? Lit LED, 1 none else.

2 respostas

Adicionar a sua resposta