SOLUCIONADA: miswiring check wiring then pwr on - Kenwood KDC-BT362U

miswiring check wiring then pwr on

A simple installation in a 1995 jeep wrangler. Kenwood KMR-D562BT. The radio runs perfectly with ignition in "Accessory" position. It also works perfectly in the "ignition ON position. But 2-3 minutes after I start the engine I get MISWIRING CHECK WIRING THEN POWER ON. I have tried "reset" I have checked to no avail to see what is the difference in power in or out between ignition ON and engine running. Nope. I cleaned all the little wires running to the circuit board. Nope Mysterious.

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não

Pontuação 0

Postado: 31 de ago de 2021

Opções

It could be an interference problem since it only happens with the engine running. Make sure you have all the speaker wires and there terminals insulated.

Esta resposta foi útil?

Sim Não

Pontuação 1

2 comentários:

Thanks Chris. That's what the manual says as well. The wires going to the plug at the radio are firmly engaged in the plug and their insulation is intact down to the plug face. Does this mean i need to start pulling out speaker wiring? What if I disconnected all but one speaker at a time and see if i can isolate which one is the source of the problem? Ian

1 de set de 2021 por IAN

@ianmw Yes. That is what I would do.

1 de set de 2021 por Chris Stables

Adicionar um comentário

Kenwood KDC-BT362U

miswiring check wiring then pwr on

1 resposta

Adicionar a sua resposta