Conserte seus objetos Comunidade Loja
Participe da comunidade de reparos - Criar conta

Lançado em 16 de setembro de 2016. Modelo 1660, 1778 Disponível como GSM ou CDMA / 32, 128 ou 256 GB / Ouro Rosa, Dourado, Prateado, Preto Mattte e Preto Brilhoso.

20 Perguntas Visualizar todos | Peças para 78 Loja

Opções

Boot Loop no display

Hello Forum,

I have a problem with my Iphone 7 (qualcomm)

So i had a no service issue which i repaired (Kind of) and after replacing BBPMU i had to do a restore, on the phone i saw imei number so probably everything was soldered just fine.Till that moment device was turning on properly. So i tried to restore my phone using 3uTools and Itunes, and finally i got error -1 , and my phone was stuck on progress bar under the apple logo, nothing happened for few minutes and i decided to turn it of holding buttons. Then my phone was just looping to recovery mode, and on 3utools i clicked on EXiT recovery mode, and after that my phone is not turning on at all, on Bench power supply i can see after holding power on 60mA jumping to 200mA and turning off, and process starts again, if anyone has any idea what is the solution i’d really apericiate any kind of help :)

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não
Pontuação 0
Adicionar um comentário

1 resposta

Filtrar por:
Mais úteis Mais recentes Mais antigas
Solução escolhida

Opções

You will need to re-ball the baseband CPU but being the Qualcomm model the baseband will probably be shorted internally. If it is you could try burning the short out but it doesn’t have a good success rate.

If the keypad brings up the IMEI you might just get away with re-balling the BBCPU.

Esta resposta foi útil?

Sim Não
Pontuação 1

6 comentários:

the problem is with device not turning on couse of some other problem, not PPBMU, when i changed the chip everything was just fine

por

ill check if tigris is shorted on 5V0Usb

por

@msac1ek The baseband PMU is not the baseband CPU which I am talking about. The power readings you supplied are a signature fault for the baseband CPU.

por

Are you sure that its Just it ? , Just died after not succesful restore. After hours of working properly

por

The problem is there is no internal short on the board , When im turning on something Just doesnt work, ill get some measurements in few days , ill get better power cables and usb amp and voltage meter, and everything will show up. Im thinking something might died when i interrupted doing restore when it was unsuccesful. any idea what could die? Nand or something ?

por

Exibir mais 1 comentário

Adicionar um comentário

Adicionar a sua resposta

Msac1ek será eternamente grato(a).
Visualizações:

Últimas 24 horas: 1

Últimos 7 dias: 3

Últimos 30 dias: 8

Ao todo: 185