Ir para o conteúdo principal

another U28 chip issue or...

Ok so my g4 chimes when on button is pressed, blank screen, fan runs - nothing. I was able to get it to start a couple of times and it would run a short time before shutting down. First time it quit after moving it a few inches. second time my g4 quit it showed vertical grey/blue lines, then blank-ish screen. Seemed like it was on but showing a blank screen.

Hoping to not change out the motherboard again (did so earlier this winter) and am game to try soldering the U28. Good candidate?

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Pontuação 0
Adicionar um comentário

1 resposta

Solução escolhida

Buy the illuminated magnifying glass that iFixit sells, and also a Weller WM120 fine-point soldering iron, and some solder paste -- these three items will make the job MUCH easier.

And yes, I would say this is an ideal candidate, i.e. black screen and "fan on high". It certainly can't hurt it.

Esta resposta foi útil?

Pontuação 3
Adicionar um comentário

Adicionar a sua resposta

clay será eternamente grato(a).
Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 4

Duração total: 758