Rep: 50,7 mil
8
14
101
Any idea where I could purchase a QFN8 to DIP8 Adapter that will fit a bios chip off the 820 00875 board. The only one I have and can find is this but it is too big.
I am using the Mini Pro TL866CS
Thanks
Esta é uma boa pergunta?
Rep: 479,4 mil
35
329
971
Is this what you are looking for?? QFN8 MLP8 WSON8 U-PDFN8 probe Programming Socket 8pad IC Test Socket Pitch 0.8mm Clamshell Chip Size 43 Flash Adapter Burn in Socket
Esta resposta foi útil?
Thanks Dan. I think that one is 4x3mm I did find one by pasting your link into google that is 3x2mm which is the size of the bios chip but they are expensive. I was hoping to find just the board for a couple of dollars and just solder the chip to it but I gather they don’t make the adapter boards that small. Might be cheaper and quicker to run jumper wires from the chip to the adapter I have.
The chips are still getting smaller and its getting harder!
Pin arrays require these sockets and as the marketer them is so small they are expensive!
Últimas 24 horas: 0
Últimos 7 dias: 0
Últimos 30 dias: 1
Duração total: 253
