Accessories not gripped tightly
After tightening an accessory into place with the collett nut, it doesn’t grip enough, so tool such a saw just stops when pressed against object.
Esta é uma boa pergunta?
Pontuação
0
582177
1 resposta
Pergunta mais útil
Rep: 8,5 mil
24
12
8
Measure the shaft on the tool in question. It is probably 3/32” and you probably have a 1/8” collet installed in the collet nut. If you have lost that part or did not get it with the tool they are readily available on line.
Esta resposta foi útil?
Pontuação
2
