Under normal circumstances, I would run a jumper from the lifted pad to its corresponding lead, but in this case I have pads lifted that have a contact on both sides. I tried researching this kind of repair but I couldn’t find anything relevant for rebuilding the pad or if it is even possible. What are my options? The pins are K12 and L12.
Esta é uma boa pergunta?
Rep: 102,6 mil
10
54
291
Hard to understand your question as, if we are talking about U3101, both pins K12 and L12 are unconnected, NC, so there’s no need to run any jumper, just leave them alone.
Esta resposta foi útil?
Oh, I didn't realize that the blue pads had NC. Thank you again. This phone board application is extremely helpful!
Últimas 24 horas: 0
Últimos 7 dias: 0
Últimos 30 dias: 0
Duração total: 88
