Pular para o conteúdo principal

{A1706 / EMC 3071}—Released in June 2017, this 13" Macbook Pro features Kaby Lake processors up to 3.5 GHz Core i7 with Turbo Boost up to 4.0 GHz.

62 Perguntas Ver todas

Micro soldering Connectors Help? Will this work?

Hi,

So I desoldered the broken connector clips for the screen and removed it & removed the connectors off the flex cable too. Will wiring it using wire and UV solder mask work as seen in these images of what I am trying to do:

Block Image

https://www.dropbox.com/s/a7pu24tvd5t3ew...

Block Image

https://www.dropbox.com/s/yz27r0rcidor4t...

Will this work if solder wires back together using wire and not a connector or am I wasting my time?

I hope I explained this right and if I didn’t please let me know and I will try to reword my issue.

Thank you in advance!

Responder a esta pergunta Também tenho esse problema

Esta é uma boa pergunta?

Pontuação 0
Adicionar um comentário

kits de reparo de baterias de iPhone

Only $29.99

Buy Now

kits de reparo de baterias de iPhone

Only $29.99

Buy Now

1 Solução

Resposta Mais Útil

The problem here is more complex as the issue is not the backlights connector it’s the ribbon cable fatigues at the edge of the logic board it wraps around. Give these vids a view:

Even if you had broken the connector somehow, I wouldn’t have taken the path you took. Instead I would have replaced it with the correct connector. Patching lines should really only be used as a last resort when a trace is damaged not to bypass logic or in place of a connector.

Time for a new display assembly ;-{ Apples displays now don’t offer replaceable cables.

Esta resposta foi útil?

Pontuação 1

Comentários:

Okay, Thank you but if it wasnt the flexgate issue would this work theoretically?

I’m just curious too as if this connector broke on other boards too if you could just wire it like the way I am doing to fix it?

por

Sometimes what is an obvious solution is not that good!

Here we have a high current load (backlight LEDs) and we have a flex cable which is intended to flex.

So while the patch might work for a few days or weeks it will fail just the same from either burning up or breaking down from the movement.

One last factor is the signal. Often times we forget about the isolation of the lines where cross-talk can enter as well as the risk of a short when your patch wires are too close together with not enough insulation. This is where spaghetti tubing is needed and the path lines need to be as short as possible.

I would have made the effort to replace the connector and not try patching.

por

Adicionar um comentário

Adicionar a sua resposta

Cameron Saman será eternamente grato(a).
Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 1

Todo: 35