SOLUCIONADA: Replacement Screen goes blank when waken from idle/timeout. - iPhone 6s

Replacement Screen goes blank when waken from idle/timeout.

I wonder if anybody can give me a pointer as to what is going wrong my replacement screen for an iphone 6s, when I installed the screen i can get it only to work when the screen is popped out and has no pressure on a certain area of the screen.Once the screen is placed into the frame it works up until the screen goes idle, when its idle I try to wake it up but only the backlight works. I can pop the screen out of the frame it will start working again and once it is out I can put the phone in idle and wake it up without a problem.

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não

Pontuação 1

1 comentário

I have a similar situation

24 de fev de 2019 por xkldnamhai.com

Postado: 14 de fev de 2019

Opções

You probably have a mix of a bad quality screen and a bumped housing there and the combination of the two causes that issue. First thing to do would be to try to straighten the housing shape where it’s bumped with a small precision hammer. Or find an original used housing on the market. You could also try reducing a bit the side pressure by gently use very fine sand paper on the screen edges to reduce a bit thickness.

Esta resposta foi útil?

Sim Não

Pontuação 4

5 comentários:

I second this the housing is probably bumped/bent. Which causes pressure on the screen.

14 de fev de 2019 por Lars

The EMI shield pushing against the housing was also causing side pressure. Thanks you very much.

14 de fev de 2019 por Robert Ryan

It's usually just a bad screen. I've used lots of screens on slightly bent frames.

14 de fev de 2019 por Ben

Thank you all, I replaced the screen and it solved the problem.

24 de fev de 2019 por Robert Ryan