Rep: 3,4 mil
12
11
3
Hi,
what temperature should i use to solder the pins on the LCD-connector (1). The former owner pulled a little bit to hard, now some of the pins are...lets say disconnected.
I use a WELLER EC 2002 with a very fine tip and i already looked for a new LCD. So why shouldn´t i try to solder it, its ruined anyway.
Esta é uma boa pergunta?
Rep: 3,4 mil
12
11
3
I wanted to solder the connector back to the cable of the LCD. I've tried it with 320°C but that didn't worked. A day later the new LCD arrived so i didn't tried it anymore.
Esta resposta foi útil?
The temperature has to be above 320°C...just to get it off the unanswered list.
thanks
I am not clear on what you are soldering. The connector that the LCD plugs into on the logic board?
Esta resposta foi útil?
spam
Esta resposta foi útil?
all your answers are just links to a pay service...
Últimas 24 horas: 0
Últimos 7 dias: 0
Últimos 30 dias: 0
Duração total: 4,466
1 comentário
If one of these answers fixed your problem please hit the "accept" in list that has "History Edit Flag Accept Comment" located to the upper right of your question so we can remove it from the unanswered list. Thanks.
por mayer