I have a Maytag washer that with run fine and fill up but once it fills up it will stop. To get it going again I have to hit the front top right corner of the machine with my hand. Once I do that it starts back up and runs through the cycles perfectly. Any ideas what I should look for? Thank you
Esta é uma boa pergunta?
Rep: 249
5
3
Do you feel like the Fonz when it goes back on again? :)
If it's full of water and not spinning then it's most likely your lid switch is broke/or breaking.
When you're hitting it you're probably knocking it temporarily on and then the machine shakes and it goes off.
Try this:
Esta resposta foi útil?
Últimas 24 horas: 0
Últimos 7 dias: 3
Últimos 30 dias: 6
Duração total: 264
