LCD touching Digitizer causing weird bubble effect

Question

iPad Mini 3 Wi-Fi

Guides for the Wi-Fi version of the iPad Mini 3 (A1599). Announced on October 16, 2014, the iPad Mini 3 is the successor to the iPad Mini Retina (now known as the iPad mini 2).

61 Perguntas Visualizar todos

Parsa Manesh @parsamanesh

Rep: 11

Postado: 4 de dez de 2017

Opções

LCD touching Digitizer causing weird bubble effect

Hello

I have seen other posts about this across the website, but for some reason the issue is still persisting.

I bought a LCD to replace my damaged LCD, but the digitiser seems to be touching the LCD and creating a weird bubble effect under the digitiser.

I have taken off the film over the front of the LCD. I have checked behind the LCD to see if any dirt or anything is stuck behind it, and also the metal plate also, but nothing is there.

I have used 3m tape around the entire device also but still there.

Any ideas?

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não

Pontuação 0

Adicionar um comentário

1 resposta

Solução escolhida

Scott @scott35006

Rep: 10 mil

15

29

4

Postado: 4 de dez de 2017

Opções

Debris is the most common reason, however, sometimes it is something else.

when i get this, i usually double layer my double sided adhesive, it gives it just that little extra bit of room between the parts. (occasionally i need three.)

however, i have also had it where the battey was bloating a little bit, causing pressure to push up. that needed to be replaced.

Esta resposta foi útil?

Sim Não

Pontuação 2

2 comentários:

Thanks for your response, I've tried adding an extra layer of 3m tape and that has fixed it temporarily. The screens aren't touching now but now the screen protrudes slightly from its frame, Its no longer flush

5 de dez de 2017 por Parsa Manesh

yes. in situations like this, you do usually have to choose between one of thos two. I choose the protrusions, because it does not effect the viewing area, and most people use a case that covers that. Likely, either the part was made a couple nanometers too thick, or the frame has the slightest of warps in it.

5 de dez de 2017 por Scott

Adicionar um comentário

Thanks for your response, I've tried adding an extra layer of 3m tape and that has fixed it temporarily. The screens aren't touching now but now the screen protrudes slightly from its frame, Its no longer flush — Parsa Manesh
yes. in situations like this, you do usually have to choose between one of thos two. I choose the protrusions, because it does not effect the viewing area, and most people use a case that covers that. Likely, either the part was made a couple nanometers too thick, or the frame has the slightest of warps in it. — Scott

iPad Mini 3 Wi-Fi

LCD touching Digitizer causing weird bubble effect

1 resposta

Adicionar a sua resposta