Rep: 25
2
I replaced my factory battery with a new iFixit battery. The new battery had 70% when installed, I allowed it to die and now I put it to charge and it stays at 2%. If I unplug the computer it turns off and has to reboot.
Esta é uma boa pergunta?
Rep: 685,3 mil
3,4 mil
1,1 mil
2,6 mil
Sounds like your battery is not charging. I would suspect the mag-safe board right off the bat. What was happening with your old battery? Please download and install and run Coconut Battery then post your results so we can get a better idea of what is going on.
Esta resposta foi útil?
The old battery was swollen, so I purchased an new replacement
macOS Battery Status: Good
Battery Failure: yes
Power adapter: 85 watts
Cycle count:2
Charging with: 0 Watts
Current Charge 136 mAh
Full Charge Capacity 6891 mAh
Well it shows to be a failed battery, which is unusual for a battery with only two cycles but it does happen. I would request a replacement.
Whats up with battery failures on iFixit batteries? this is probably the 2nd one i've seen today...
Right now I don't know if it is the battery. Looks like it was run for one cycle to test it before you got it. We won't know till you try a second one. It can very well be something else.
Últimas 24 horas: 0
Últimos 7 dias: 2
Últimos 30 dias: 3
Duração total: 383
