SOLUCIONADA: Lid does not remain closed all the way but pops back up - MacBook Pro 13" Retina Display Mid 2014

Lid does not remain closed all the way but pops back up

I am having a problem with my lid not remaining closed when not in use. As I attempt to close the lid it springs back up about a quarter of an inch. There are no dents in the case and nothing on the exterior that looks suspect. It seems as though the magnets do not engage preventing it from closing all the way. Has anyone experienced this problem? Is there a fix to realign the magnets? Please help. Thanks in advance.

Respondido! Ver a resposta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não

Pontuação 2

Postado: 11 de fev de 2017

Opções

Could be a few things;

1. If the screen has not been replaced previously, remove the bottom cover and rubber hinge covers, and loosen all 6 hinge screws. Align the lid slightly and tighten the screws, see if it has the same issue. Loosening the screws slightly and leaving them like this can also resolve the problem. Usually caused by bend in aluminium by the hinge cover.

2. If screen has been replaced, it is possible they have sold you one with no magnet inside the lid (has happened to me before)

3. If it is a new screen and not original, there is possibly a bump in the rubber bezel, which causes it to not close properly. Feel the bezel around the screen to check this

Esta resposta foi útil?

Sim Não

Pontuação 3

2 comentários:

Also the hinge clutch can also bind up a bit, which will require replacing the hinges.

11 de fev de 2017 por Dan

Hi Reece and Dan,

Thank you both for your suggestions. Loosening the hinge screws and slightly realigning the lid worked for me. I really appreciate it.

13 de fev de 2017 por Bernie

Adicionar um comentário

MacBook Pro 13" Retina Display Mid 2014

Lid does not remain closed all the way but pops back up

1 resposta

Adicionar a sua resposta