Whirlpool quiet partner ii clean light flashing 7 times. I installed a new heating element and reset the code, and it still flashes 7 times
Not sure what to do now?
Any help will be appreciated.
Thanks
Chris
Esta é uma boa pergunta?
Rep: 685,4 mil
3,4 mil
1,1 mil
2,6 mil
The flashing "clean light" indicates, a water temperature, heating problem.
It could be due to, a bad heater element, thermostat, or a control board.
Most of the time, it's due to a low water temperature.
You need to make sure, the water temperature, in the bottom of the tub, on the first fill of a wash cycle, is at least 120 to 130 dgrs. F. (you should be able to run the hot water faucet at the kitchen sink, and get somewhere in that range, before you start the dishwasher).
Read more: http://forum.appliancepartspros.com/dish...
Esta resposta foi útil?
Últimas 24 horas: 0
Últimos 7 dias: 24
Últimos 30 dias: 108
Duração total: 15,559
1 comentário
I have the same issue - once it was replaced, it is heating the water but after the rinse the light will flash again 7 times. I have reset but still have the. BLinking light
por Brian fulp