After scouring the official Apple Watch page, it doesn't look like there are any screws on the outside casing of the Apple Watch.
Perhaps the screen is glued to the body unit? I'd imagine one would need to take a heat gun to the screen to pry it off and then remove the individual components of the watch.
Any thoughts / conjectures?
Esta é uma boa pergunta?
Rep: 479,9 mil
35
329
971
Given Apples direction over the last few years I suspect they are using Glue or Magnets if you can't see any screws. We'll need to wait until IFIXIT team gets their hands on one.
Esta resposta foi útil?
I have hopes and I have fears.
I hope it's soon!
I'm going to guess that would be friday!
Rep: 90 mil
107
35
452
Rep: 74 mil
19
111
82
Probably the same tricks the watchmaking industry has been using: Screw-down or clip-on back cover.
But it's Apple, I wouldn't bet on it.
BTW, glued-up watch face is also a standard practice for watchmaking industry, you can' blame that one on Apple.
Esta resposta foi útil?
what should i do to open back cover of apple watch ?
Esta resposta foi útil?
Últimas 24 horas: 0
Últimos 7 dias: 8
Últimos 30 dias: 14
Duração total: 1,898
