Conserte seus objetos Comunidade Loja

Apple's 2012 first-generation 7.9-inch iPad mini, with 16, 32, or 64 GB of storage and an A5 processor.

630 Perguntas Visualizar todos
Pergunta encerrada

Opções

potential problems by soldering the ic chip incorrectly?

Hi

is there any potential pronlems if I solder my own ic chip to a new digitiser? Would it blow anything if a couple of contacts were touching? Or would it simply not work?

Would like to practice this, but not at the expense of someones ipad when i repair it.

would be handy to do, as im fed up of these cheap ones which flicker everytime I lay it flat, and have to cover it in tape.

Thanks

Responder a esta pergunta Também tenho esse problema

Esta é uma boa pergunta?

Sim Não
Pontuação 0
Adicionar um comentário

1 resposta

Filtrar por:
Mais úteis Mais recentes Mais antigas
Pergunta mais útil

Opções

Most likely worst case scenario: dead device.

Update

If you don't do it right, you could get the power leads or voltage to where they don't belong. Hence possibility of a dead device is strong.

Esta resposta foi útil?

Sim Não
Pontuação 2

3 comentários:

Is that fact or just a guess? Just that I would think as the connections would only ne sending signals, then I would imagine the digitiser would go a bit loopy as if the flex cable was pinched? But that's just a guess. Wonder if anyone has actually done it wrong? I know all the local repair shops in this area don't solder the parts.

por

If you don't do it right, you could get the power leads or voltage to where they don't belong. Hence possibility of a dead device is strong.

por

Ok, I'm not really experienced at soldering, but practice makes perfect.

wonder if there's some sort of schematic for that connection?

por

Adicionar um comentário
Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 9

Últimos 30 dias: 12

Duração total: 118