Este usuário ainda não preencheu o perfil.
Perguntas
Hi everybody here, I just read a lot about diagnostics LEDs here and will give them a try when I have access to my iMac in...
Saiba maisHi everybody, I’ve got problems with an iPod Classic 160 GB, 6th gen. („thick“). The HD was faulty, so I decided to...
Saiba maisAm I right, that I can upgrade my 6th gen. iPod Classic 160 GB ("thick", actually using a 160 GB HDD with CE-ATA-Interface...
Saiba maisRespostas
I had the PFM006 error, too. Fans were rotating at maximum speed, process “kernel_task” was around 500%. This happened after a battery replacement. The trackpad cable had a very small damage. Therefore, its sensor weren’t able to report their status (palm rest, temperature etc.). So, the system thought there was a temperature issue and fired up the fans. But this didn’t help (still no response from the sensors), so the kernel restarted over and over. After implementing a new Trackpad cable everything returned to normal. “SMC” was just fine all the time - the error code was misleading in this case.
Saiba maisI had the PFM006 error, too. Fans were rotating at maximum speed, process “kernel_task” was around 500%. It also happened after a battery replacement. The trackpad cable had a very small damage. Therefore, its sensor weren’t able to report their status (palm rest, temperature etc.). So, the system thought there was a temperature issue and fired up the fans. But this didn’t help (still no response from the sensors), so the kernel restarted over and over. After implementing a new Trackpad cable everything returned to normal. “SMC” was just fine all the time - the error code was misleading.
Saiba maisI had the same problem. Only external video, LED4 of. In my case, inductor L9000 of the logic board was gone. If you want, have a look at my post After HD changed, fuse (wall) tripped, no internal video, but external Regards.
Saiba maisI had the same problem: Only external video, LED 4 not lid. It was a faulty inductor on the main board. Look: After HD changed, fuse (wall) tripped, no internal video, but external Regards.
Saiba maisI had the same problem: Only external video, LED 4 not lid. It was a faulty inductor on the main board. Look: After HD changed, fuse (wall) tripped, no internal video, but external Regards.
Saiba maisI had the same problem: Only external video, LED 4 not lid. It was a faulty inductor on the main board. Look: After HD changed, fuse (wall) tripped, no internal video, but external Regards.
Saiba maisI had the same problem. The reason was not the LVDS Connector but an exploded inductor on the main board. Maybe you want to have a look at After HD changed, fuse (wall) tripped, no internal video, but external Greetings from Hamburg
Saiba maisThe logic board needed repair: inductor L9000 was burned: This is a detail of the circuit diagram: When the inductor was replaced, the internal screen started working again. Hooray! Some had trouble to locate the inductor. Here is an image that should be helpful:
Saiba maisOlaf
@multifinder
193
Reputação
8
Soluções
0
Guias
Membro desde 12/03/13