Desmontagens analíticas (teardowns) nas quais trabalhei
Guias para os quais contribuí
Resposta para "New to phone repair, need to replace screen on Doogee Mix 2."I’ve just replaced the power board on a Doogee Mix 2. The most stressful part is removing the back. Unless you are really good at it I would buy a new back cover and a new set of patch antennas from Aliexpress before you start. The back cover is about $6 and the patch antennas about $5. Disassembly is the usual process of heating the back of the phone, ideally with a temperature controlled heat mat but you can use a heat gun if you are careful. With a very thin spudger you can pry the back cover away from the phone very gently, the glass will probably crack. Pry only in the lower half of the back cover. When you have enough room, insert some plastic shims (such as plastic playing cards) and use them to cut through the glue. On the Mix2 the battery is glued to the back cover, so you will have to be very careful to cut the glue between the battery and the back cover before lifting the back covery very much otherwise you will damage the cable connecting the battery to the motherboard. Unless you are very...
Resposta para "Why isn't my update restarting the phone?"You may need to wipe the cache: http://bbs.vernee.cc/forum.php?mod=viewt...
Resposta para "Poor performance of Ulefone Be Pro screen."I have a Be Pro with the same problem. I think the digitizers go bad after a while. You can buy a new screen/digitizer module but it's difficult to do and economically questionable: https://www.aliexpress.com/item/Free-Repair-Tools-100-Original-Ulefone-be-Pro-LCD-Display-Digitizer-Touch-Repair-Assembly-Black-Replacement/32710935049.html I just bought a new phone and relegated the Be Pro to car navigation, which doesn't use the digitizer so much.
Resposta para "Does not drain the water at the end of cycle"Another possibility is that your drain pump is stalling. The usual design is with a rotor containing a permanent magnet. If the bearings are sticky then the rotor sometimes doesn't return correctly to the park position which means the pump stalls when it tries to run again. If your pump is like this then unscrew it (usually 3 screws), pull the rotor assembly out of the housing, clean and grease the bearings then reassemble.
Resposta para "Why does my computer turn off after a few minutes run time?"There's a fair chance the fan or radiator are blocked with lint. Try removing the fan (instructions may be on here depending on model) and have a look.