Computer and mobile device repair, service, and accessories.
Evento | Contagem | Delta |
---|---|---|
Voto à favor da postagem | 146 | 1752 |
Resposta aprovada | 36 | 1080 |
Alguém completou seu guia | 35 | 132 |
Resposta Aceita | 4 | 40 |
Edição patrulhada de um passo de um guia aceita | 2 | 2 |
Edição patrulhada da introdução de um guia aceita | 1 | 1 |
Votou negativo para o post | 7 | -14 |
Voto contra à postagem | 4 | -24 |
Seu comentário foi apagado por ter sido marcado como inapropriado | 3 | -300 |
This is unnecessary. You need only open the tan cable release latch from either end of the cable, remove the cable from the socket, and move the cable out of the way.
I believe a revision needs to be made to this guide.
I have a Beats Studio headphone with a “v1.8” revision motherboard, and there is an additional wire in play. Look at the picture of the motherboard in step 14 of this guide. In the upper-right “corner” is one of the screw holes that holds the motherboard to the housing, and directly above it is a large round solder pad. On the v1.6 motherboard this pad is empty, but on the v1.8 motherboard there’s a single-conductor wire that goes from that pad to the very tip of the metal “spring band” that goes over your head while wearing the headphones. Yes, it’s soldered directly to that “spring band”. I suspect this is some kind of grounding wire.