Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Peças e ferramentas

Ferramentas utilizadas neste teardown

Introdução

This is a basic teardown of the venerable TI-82 calculator.

Este teardown (desmontagem analítica) não é um guia de reparo. Para reparar seu/sua Texas Instruments TI-82, use o nosso manual de serviço.

  1. The calculator comes with a matching protective shield which slides down over the front; when the calculator is in use, you can slide it over the back.  This is a nice touch, as it makes the cover much more difficult to lose.
    • The calculator comes with a matching protective shield which slides down over the front; when the calculator is in use, you can slide it over the back. This is a nice touch, as it makes the cover much more difficult to lose.

  2. Flip the device over to access the battery cover. Using a spudger, pry the release tab down and then pull the battery door up and off the calculator. Remove:
    • Flip the device over to access the battery cover.

    • Using a spudger, pry the release tab down and then pull the battery door up and off the calculator.

    • Remove:

    • 2 7.2mm Phillips #0 screws

    • 1 15.3mm Phillips #0 screw, and a battery retaining clip.

    • The CR1616 coin cell battery preserves settings and programs in memory while the main batteries are being changed.

  3. Kit de pontas universal para chave

    112 bits for every fix.

    Upgrade Your Toolbox

    Kit de pontas universal para chave

    Upgrade Your Toolbox
  4. Insert a spudger into the seam between the two halves of the case, and pry it apart.
    • Insert a spudger into the seam between the two halves of the case, and pry it apart.

    • Watch out for corrosion in older calculators around the battery terminals -- this is why you should never leave batteries in electronics for extended periods of time.

  5. Opening the two halves of the calculator reveals a foil shield over the rest of the electronics.
    • Opening the two halves of the calculator reveals a foil shield over the rest of the electronics.

    • Remove four Phillips screws to access the electronics underneath, then pull the shield away.

  6. ... And, here's the guts of the thing.
    • ... And, here's the guts of the thing.

    • SRM20255LLM10 / F4ZM1938 (32Kbyte SRAM)

    • LH531GP4 (Mask ROM)

    • T 84C00AM-8 (Z80 CPU)

    • Toshiba / TC14L010AF / 1273 9506EAI (ASIC)

  7. Remove the remaining Phillips screws. The screen and main board will lift out, leaving the membrane keypad in the front case.
    • Remove the remaining Phillips screws.

    • The screen and main board will lift out, leaving the membrane keypad in the front case.

bushing

Membro desde: 23-04-2010

9.771 Reputação

13 Guias de autoria

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 18

Últimos 30 dias: 52

Duração total: 16,329