Introdução

The Sony Ericsson s710a is a camera phone with all of the features expected of a phone in the mid '00's.

This teardown is not a repair guide. To repair your Sony Ericsson s710a, use our service manual.

Remove the back cover by sliding it off.
  • Remove the back cover by sliding it off.

Adicionar comentário

Once the back cover is removed, pull out the battery using your finger as shown.
  • Once the back cover is removed, pull out the battery using your finger as shown.

Adicionar comentário

The battery can now be replaced if desired.
  • The battery can now be replaced if desired.

    • The battery is a 780 mAh rechargeable Lithium Ion battery.

Adicionar comentário

Remove the four 6mm screws behind the battery.
  • Remove the four 6mm screws behind the battery.

Adicionar comentário

Remove plastic piece near the base of the keypad. This will require prying it off with a plastic opening tool and breaking the seal with the glue. Unfortunately there is no way around this.
  • Remove plastic piece near the base of the keypad.

    • This will require prying it off with a plastic opening tool and breaking the seal with the glue. Unfortunately there is no way around this.

  • Then remove the two 6mm screws beneath the plastic cover with a Phillips head screw driver.

  • Now you are ready to remove the plastic back cover.

Adicionar comentário

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Use the plastic opening tool to pry off the back cover of the phone. This will require a bit of careful work. You should start prying the back cover from the SD card slot.
  • Use the plastic opening tool to pry off the back cover of the phone. This will require a bit of careful work.

  • You should start prying the back cover from the SD card slot.

  • Alternate prying the back cover on each side until it pops off.

Adicionar comentário

Use the plastic opening tool to carefully pry out the circuit board once you have removed the back cover.
  • Use the plastic opening tool to carefully pry out the circuit board once you have removed the back cover.

Adicionar comentário

Remove the LCD cable connectors coming from through the hinge hole with a flat head screw driver.
  • Remove the LCD cable connectors coming from through the hinge hole with a flat head screw driver.

  • IMPORTANT: be sure to record which port each cable was in and the orientation they were plugged into each socket.

  • Now the two parts of the phone are separated.

Adicionar comentário

On the non-camera side of the phone, remove the four 3mm screws and two 2.3mm screws holding down the twist-structure.
  • On the non-camera side of the phone, remove the four 3mm screws and two 2.3mm screws holding down the twist-structure.

  • When you lift this off, you will need to disconnect the cables from the other side using the same method as in step 5.

  • Again, be sure to record which port each cable was in and the orientation they were plugged into each socket.

Adicionar comentário

Remove the plastic piece near the bottom of this side of the phone with the plastic opening tool. This will give you access to two additional screws. Remember you will have to break the glue seal, but that is alright.
  • Remove the plastic piece near the bottom of this side of the phone with the plastic opening tool. This will give you access to two additional screws.

  • Remember you will have to break the glue seal, but that is alright.

  • Remove the four visible 6mm screws and then remove the back cover.

Adicionar comentário

In order to remove the LCD screen, use the plastic opening tool to pry the plastic piece from the LCD. Perform this step carefully to avoid scratching the glass screen.
  • In order to remove the LCD screen, use the plastic opening tool to pry the plastic piece from the LCD.

  • Perform this step carefully to avoid scratching the glass screen.

Adicionar comentário

In this picture, you can see all of the parts in the non-camera side of the phone.
  • In this picture, you can see all of the parts in the non-camera side of the phone.

  • Interestingly, the four control buttons are all one piece

Adicionar comentário

This phone has an array of capabilities:
  • This phone has an array of capabilities:

    • Bluetooth

    • Megapixel Camera

    • MP3 capable

    • Messaging options

  • This photograph shows the final result of a complete teardown.

Adicionar comentário

Alexander

Member since: 29-10-2011

75 reputação

8 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 4

Todo: 3,842