Introdução

The Teardown is pretty much the same as other Samsung Slider phones

This teardown is not a repair guide. To repair your Samsung Intensity, use our service manual.

Remove the back cover and battery
  • Remove the back cover and battery

Adicionar comentário

Remove the 8 screw that hold the back cover down.
  • Remove the 8 screw that hold the back cover down.

  • Carefully pry back piece off

  • Start at the bottom and work toward the top.

Adicionar comentário

Use the ipod opening tool to disconnect the Connector
  • Use the ipod opening tool to disconnect the Connector

Adicionar comentário

Carefully remove the main board Make sure to not tear the microphone cable, pry it from the phone carefully
  • Carefully remove the main board

    • Make sure to not tear the microphone cable, pry it from the phone carefully

Adicionar comentário

Remove the 6 screws Pry to ribbon cable assembly loose from the slider
  • Remove the 6 screws

  • Pry to ribbon cable assembly loose from the slider

  • Its glued on the left and right side

Adicionar comentário

Remove the 4 screw the holds the slider to the phone assembly
  • Remove the 4 screw the holds the slider to the phone assembly

  • one of the screws will be behind the hinge

  • Carefully pry slider assembly loose from display assembly

Adicionar comentário

Remove the tape and pop the connectors and pull all the ribbon cables loose Carefully pry the speaker loose from the case. Carefully pry the speaker loose from the case.
  • Remove the tape and pop the connectors and pull all the ribbon cables loose

  • Carefully pry the speaker loose from the case.

Adicionar comentário

Carefully work the keyboard loose from the display assembly
  • Carefully work the keyboard loose from the display assembly

  • There are a couple fragile clips that hold it in place

Adicionar comentário

LCD comes out pretty easily Pry it from the bottom and work up the sides to release it if stuck
  • LCD comes out pretty easily

  • Pry it from the bottom and work up the sides to release it if stuck

  • The glass can be removed with a little heat from a heat gun or blow dryer

  • Pry it out from the outside edges working around carefully

Adicionar comentário

David

Member since: 10-08-2011

110 reputação

Autoria de 1 guia

Equipe

West Georgia Technology Membro de West Georgia Technology

Business

1 Membro

1 Guide authored

This was so helpful! How can I show my gratitude to you for these helpful instructions?

teh_pwnerer22 - Responder

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 2

Últimos 30 dias: 16

Todo: 3,614