Ferramentas utilizadas neste teardown

Introdução

Going to take apart my Power Mac 8600/250!

Tools:

#1 Phillips screwdriver

Spudger/Flathead screwdriver

Your hands!

Este teardown (desmontagem analítica) não é um guia de reparo. Para reparar seu/sua Power Macintosh 8600(250), use o nosso manual de serviço.

  1. There she is! i'm missing the bezel around the floppy drive :(
    • There she is! i'm missing the bezel around the floppy drive :(

    Adicionar comentário

  2. Start by pressing the big green button. And pulling the door away and up from the computer.
    • Start by pressing the big green button. And pulling the door away and up from the computer.

    • And on the Back of the door is the fan.

    Adicionar comentário

    • Now it's best to lay the computer flat.

    • And to flip up the tabs, grab the handle and open.

    Adicionar comentário

    • The innards, motherboard, daughter board, RAM and so fourth.

    Adicionar comentário

    • Now the speaker

    • Remove the speaker wires

    • And the fan wires from the motherboard

    • Push in the two plastic tabs on either side and lift the speaker up and out.

    Adicionar comentário

  3. GIVE TOOLS. FIX FOREVER.

    GIVE TOOLS.

    FIX FOREVER.

    Spread the Fixmas cheer.

    GIVE TOOLS. FIX FOREVER.

    Spread the Fixmas cheer.

    • The PRAM battery!

    • Remove the housing by pulling it out and then take the battery out.

    Adicionar comentário

    • The processor, firmly grasp and pull out.

    • Remove the 4 #1 Phillips screws

    • And push the 4 tabs off of the board

    High failure rate - these bassas’

    Mal - Responder

    • Any video card or usb card, mine happens to be an ethernet 10/100 card.

    • Unfortunately there are 6 spaces but only 3 slots on the motherboard :(

    • Remove the #1 Phillips screw and pull the card out.

    Adicionar comentário

    • RAM and VRAM slots!

    Adicionar comentário

    • Moving on to the CD, ZIP, and Floppy drives (best to close computer now)

    • Remove the bezels and if I had the top one remove that too.

    • Remove the 6 phillips screws and pull the metal frames out.

    Adicionar comentário

    • Remove the data and power cables

    • Pay special attention to this one, it has a clip on it, it helps to use a flathead or a spudger.

    • Pull the drives out of the bay.

    Adicionar comentário

    • Now the hard drive.

    • Remove the two phillips screws

    • And the data and power cables (might help to remove them as you pull the drive out)

    Adicionar comentário

    • The power source

    • Remove the two connectors

    • There is a clip holding the wires in place. Separate and remove the wires. (both sets)

    Adicionar comentário

    • Now remove the 4 phillips screws (it's best to start with the bottom two)

    • And pull it out while de-threading the wires.

    Adicionar comentário

Plague

Member since: 14-06-2010

171 reputação

Autoria de 1 guia

Nice. I got a beige G3 300 Mhz, the case is similar. Maybe I could also make a teardown.

Nicolas Zbinden - Responder

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 7

Últimos 30 dias: 24

Todo: 13,383