Ir para o conteúdo principal
  1. Unplug the device before following this guide. First, place the device on its side, making sure the switch is not facing down.
    • Unplug the device before following this guide.

    • First, place the device on its side, making sure the switch is not facing down.

    • Remove the eight 12mm Phillips #02 screws from the base.

  2. Gently separate the panel from the device.
    • Gently separate the panel from the device.

    • Be sure not to tug at the wires that are still connected.

  3. Locate the tie strap holding the wires and cut with a pair of scissors. Use care not to snip the wires.
    • Locate the tie strap holding the wires and cut with a pair of scissors.

    • Use care not to snip the wires.

  4. Make note of the wiring arrangement of each bundle before this step. Using wire cutters, cut each wire as close to the wire connector as possible. Cut the wires in both bundles.
    • Make note of the wiring arrangement of each bundle before this step.

    • Using wire cutters, cut each wire as close to the wire connector as possible.

    • Cut the wires in both bundles.

    • To reassemble the cotton candy maker after cutting the wires, follow our rewiring guide.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Joshua Harriger

Membro desde: 13/01/2015

309 Reputação

2 Guias de autoria

Equipe

USF Tampa, Team 3-5, Hickman Winter 2015 Membro de USF Tampa, Team 3-5, Hickman Winter 2015

USFT-HICKMAN-W15S3G5

5 Membros

8 Guias de autoria

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 85