Esta versão pode conter edições incorretas. Mude para o último instantâneo verificado.
O que você precisa
-
Este passo não foi traduzido. Ajude a traduzi-lo
-
Remove both T3 screws
-
Slide off the plastic piece by lifting out and then up
-
Slide plastic and spring assembly off the rail
-
-
Este passo não foi traduzido. Ajude a traduzi-lo
-
Heat the glass screen with a blowdryer to soften the adhesives
-
Insert a razor blade between the glass and the body
-
Keep going around the rim of the display until loose
-
-
-
Este passo não foi traduzido. Ajude a traduzi-lo
-
Remove two T2 screws
-
Remove T3 screw
-
Liftoff metal shield
-
-
Este passo não foi traduzido. Ajude a traduzi-lo
-
Disconnect vibrator motor
-
Disconnect heartrate and charging connector
-
Remove altimeter
-
-
Este passo não foi traduzido. Ajude a traduzi-lo
-
Remove button assembly from case
-
Remove vibrator motor
-
-
Este passo não foi traduzido. Ajude a traduzi-lo
-
Remove motherboard
-
It seems as if the heart rate sensor and charging pins are molded into the case, and I was not able to remove them
-
Cancelar: não concluí este guia.
2 outras pessoas executaram este guia.
12 comentários
The tear down pictures are great, but in my Charge 3 I needed a T-1 and a T-2 driver
Same, my ifixit pro kit only had a driver for the external screws and did not come with a small enough driver to remove the screws inside the charge 3 unit. I'll need to get the smaller bit from a different kit.
Which step in the teardown guide needed the T1 driver?
This tear down was very easy to follow. The heart rate monitor was also sealed in with some adhesive for me too but a little heat gun took it right off. I had suspected water leaked in and that in fact was the culprit after inspecting the connection. corrosion all around the HR monitor.