Ir para o conteúdo principal

O que você precisa

Este teardown (desmontagem analítica) não é um guia de reparo. Para reparar seu/sua Caterpillar B15, use o nosso manual de serviço.

  1. Este passo não foi traduzido. Ajude a traduzi-lo

    : passo 1, imagem 1 %32
    • Place the phone screen-side down and place thumb on the yellow and black switch. Slide the switch to the right to unlock the back covering for removal.

  2. Este passo não foi traduzido. Ajude a traduzi-lo

    : passo 2, imagem 1 %32 : passo 2, imagem 2 %32
    • Remove the back covering by gently lifting upwards from the bottom of the back covering. The back will snap off and the battery is exposed.

  3. Este passo não foi traduzido. Ajude a traduzi-lo

    : passo 3, imagem 1 %32 : passo 3, imagem 2 %32
    • Place index finger at the top edge of the battery and gently lift upwards. The battery will slide cleanly out of the phone.

  4. Este passo não foi traduzido. Ajude a traduzi-lo

    : passo 4, imagem 1 %32 : passo 4, imagem 2 %32
    • With the back cover removed, locate and remove the Phillips screw pictured top-center, and the two torx screws above and to either side of the Phillips screw. A T-5 bit is required for removal of the torx screws.

    • WARNING: Proceeding beyond this point will void the warranty for this device.

  5. Este passo não foi traduzido. Ajude a traduzi-lo

    : passo 5, imagem 1 %32
    • Next, remove the two torx (star-shaped) screws below the battery. These screws help to secure the outer shell of the phone around the motherboard. A T-5 bit is required for removal.

  6. Este passo não foi traduzido. Ajude a traduzi-lo

    : passo 6, imagem 1 %32
    • There are three remaining screws on each long side of the phone. A small hex bit is required for removal.

  7. Este passo não foi traduzido. Ajude a traduzi-lo

    : passo 7, imagem 1 %32
    • There is one more Phillips screw remaining. It is located beneath the headphone cover.

  8. Este passo não foi traduzido. Ajude a traduzi-lo

    : passo 8, imagem 1 %32
    • With all screws removed, the back and side pieces should come off the front of the phone, exposing the motherboard and various components as shown.

  9. Este passo não foi traduzido. Ajude a traduzi-lo

    : passo 9, imagem 1 %32
    • With all screws removed, move around the motherboard, carefully prying it from the remaining shell.

  10. Este passo não foi traduzido. Ajude a traduzi-lo

    : passo 10, imagem 1 %32
    • Finally, disconnect the chip seen in the upper right, and the board should pull away from the rest of the phone.

  11. Este passo não foi traduzido. Ajude a traduzi-lo

    : passo 11, imagem 1 %32
    • Congratulations. You have successfully disassembled the Caterpillar B15.

Geoffrey Mosdell

Membro desde: 10/06/14

1.119 Reputação

Autoria de 5 guias

Equipe

USF Tampa, Team 4-7, Brown Fall 2014 Membro de USF Tampa, Team 4-7, Brown Fall 2014

USFT-BROWN-F14S4G7

Membros da 4

Autoria de 10 guias

2 comentários

Hi,

where can i buy T5 Torx screws for CAT B15 ?

Regards,

Laurent NOEL

Laurent NOEL - Responder

Any idea where I can get the rubber piece that covers the USB port? The one repair shop in the US wants about $200 for that repair.

John Nagle - Responder

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 2

Últimos 7 dias: 13

Últimos 30 dias: 26

Duração total: 11,432