Skip to main content

Aviso: Você está editando um guia tipo pré-requisito. Quaisquer alterações que você faça afetarão todos os 22 guias que incluem este passo.

Inglês
Alemão

Traduzindo o passo 1

Step 1
Pull the LCD temperature sensor connector straight up out of its socket on the logic board. If necessary, de-route the LCD temperature sensor cable from behind the logic board.
  • Pull the LCD temperature sensor connector straight up out of its socket on the logic board.

  • If necessary, de-route the LCD temperature sensor cable from behind the logic board.

  • When you remove the LCD, check the routing of the LCD temperature display cable. On reinstalling the display, be sure this cable does not block one of the bottom screws for the front bezel.

Ziehen Sie den Stecker des LCD-Temperatursensors gerade nach oben aus dem Sockel auf der Hauptplatine.

Ziehe dabei falls erforderlich das Kabel des Sensors hinter der Hauptplatine hervor.

Überprüfe beim Ausbau des LCD die Kabelführung des Sensors. Achte darauf, dass das Kabel beim Wiedereinbau des Bildschirms nicht eine der Schrauben für die Frontblende blockiert.

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.