Ir para o conteúdo principal

Aviso: Você está editando um guia tipo pré-requisito. Quaisquer alterações que você faça afetarão todos os 12 guias que incluem este passo.

Inglês
Japonês
Passo 8
Be very careful not to touch the capacitor leads or any exposed solder joints on the back of the power supply. Only handle the board by the edges. Do not let any of the exposed solder joints come in contact with a metal surface, as that can cause a short. Flip the power supply over to access the DC power cable connection behind the logic board.
  • Be very careful not to touch the capacitor leads or any exposed solder joints on the back of the power supply. Only handle the board by the edges.

  • Do not let any of the exposed solder joints come in contact with a metal surface, as that can cause a short.

  • Flip the power supply over to access the DC power cable connection behind the logic board.

  • To disconnect the cable, squeeze the release clip on the back side of the connector, behind the logic board, and pull the connector straight out.

コンデンサのリード線や電源装置の背面にあるはんだ接合部の露出面に触れないように、くれぐれもご注意ください。 ボードの端のみを扱ってください。

露出したはんだ接合部がメタル表面に接触しないようにしてください。接触してしまうと、ショートしてしまう可能性があります。

電源を裏返して、ロジックボードの背後にあるDC電源ケーブル接続にアクセスします。

ケーブルの接続を外すには、ロジックボードの裏側にあるコネクタの裏側のリリースクリップを摘んで、コネクタをまっすぐ引き出します。

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.