Ir para o conteúdo principal

Aviso: Você está editando um guia tipo pré-requisito. Quaisquer alterações que você faça afetarão todos os 2 guias que incluem este passo.

Inglês
Japonês
Passo 5
If you successfully removed both adhesive strips, move on to the next step. Otherwise, you will need to pry the battery from the rear case. Prepare an iOpener and apply it to the back of the rear case, directly over the battery. Alternatively, you can apply heat using a heat gun or  hair dryer.
  • If you successfully removed both adhesive strips, move on to the next step. Otherwise, you will need to pry the battery from the rear case.

  • Prepare an iOpener and apply it to the back of the rear case, directly over the battery. Alternatively, you can apply heat using a heat gun or hair dryer.

  • After about a minute, remove the iOpener, flip the phone over and use a plastic card to break up any remaining adhesive behind the battery.

  • Avoid bending the battery. Damage to the battery may release dangerous chemicals, and could start a fire.

  • Do not pry under the top third of the battery, you may damage the volume button ribbon cable.

2本の接着ストリップを取り出せたら、次の手順に進んでください。2本とも取り出せなかった場合は、リアケースからバッテリーを外さなければなりません。

iOpener を準備してリアケースの裏側、バッテリーの上に直接当てます。あるいはヒートガンやドライヤーを使用することもできます。

約1分後iOpenerを外して、デバイスを裏返します。プラスチックカードを差し込んで、バッテリーに残っている圧着剤を剥がします。

バッテリーが変形しないようにご注意ください。バッテリーにダメージを与えると危険な化学物質が排出されて引火の原因となります。

バッテリー上部1/3の底をこじ開けないでください。ここにボリュームボタンのリボンケーブルが接続されており、ダメージを与えてしまいます。

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.