Ir para o conteúdo principal

Fix Your Stuff

Right to Repair

Parts & Tools

Inglês
Alemão
Step 2
Using a nylon spudger, or with care a small flat screwdriver, ease the rear cover away from the main body of the iron on both sides, starting at the top near the cable entry. Once the rear cover starts to come away you can increase the gap created by inserting the spudger a little further down. Note the tab on the rear cover shown in the 3rd photo  which was holding the rear cover in place. On reassembly this can't be re-inserted without lifting the top cover (see Step 7 later).
Rear cover removal - 2
  • Using a nylon spudger, or with care a small flat screwdriver, ease the rear cover away from the main body of the iron on both sides, starting at the top near the cable entry.

  • Once the rear cover starts to come away you can increase the gap created by inserting the spudger a little further down.

  • Note the tab on the rear cover shown in the 3rd photo which was holding the rear cover in place. On reassembly this can't be re-inserted without lifting the top cover (see Step 7 later).

Beginne auf jeder Seite des Kabeleintritts mit einem Spudger oder einem Flachschraubendreher die Rückabdeckung abzulösen

Wenn sich der Deckel beginnt zu lösen kannst du mit dem Spudger den Spalt vergrößern.

Beachte die Lasche an der Rückabdeckung, die den Deckel festhält, wie im dritten Foto zu sehen. Beim Wiederzusammenbau kann sie nicht wieder eingesetzt werden, ohne die obere Abdeckung hochzuheben (siehe später Schritt 7)

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.