Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Peças e ferramentas

Aviso: Você está editando um guia tipo pré-requisito. Quaisquer alterações que você faça afetarão todos os 19 guias que incluem este passo.

Inglês
Alemão

Traduzindo o passo 1

Passo 1
In this step you will disconnect the battery to help avoid shorting out any components during service. Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.
  • In this step you will disconnect the battery to help avoid shorting out any components during service.

  • Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.

  • Bend the battery cable slightly away from the logic board so the connector will not accidentally contact its socket.

In diesem Schritt wirst du den Akku abtrennen, um Kurzschlüsse an irgendwelchen Komponenten während der Reparatur zu vermeiden.

Hebele mit dem flachen Ende eines Spudgers die beiden kurzen Seiten des Akkusteckers nach oben, um ihn von seinem Anschluss auf dem Logic Board zu lösen.

Biege das Akkukabel etwas weg vom Logic Board, so dass sich der Stecker nicht wieder versehentlich mit dem Anschluss verbinden kann.

Suas contribuições são licenciadas pela licença de código aberto Creative Commons.